THE CIMPLE CO – Dual, Twin, or Siamese Coaxial Cable Clips, Cat6, Electrical Wire Cable Clip, 1/2 in Screw Clip and Fastener, Black (100 Pieces per Bag)
THE CIMPLE CO, A Family Company located in the USA, is proud to offer these clips. They are available with Nail or Screw fastener, manufactured with high quality UV protected materials and long-life outdoor rated fasteners. By using specially designed clips for coax, data, and other cables-there is no loss in the wire by ‘pinching or crushing’ the outer jacket. This leaves the integrity of the cable intact to prevent any loss of signal, while providing a long-life installation. Screw clips are designed to be removed and adjusted if every needed; nail clips are great for baseboards, most stucco, and brick mortar. Available in sizes to fit a single cable, or two – and in black and white.
Added ridges ‘lock’ the clip in place, allowing it to automatically adjust to a wide variety of Cable and wires sizes. Allows for near 360 degrees of grip, so that the Cable will not slide back and forth for most sizes.
High Quality, Outdoor Rated, UV Protected PE Clip and Long-Life Yellow Zinc plated screw anchors are designed to be strong and easy to install. They are pre-installed into the clip, saving time and making installation much easier.
Twin mounting head allow for the use of either a 1/4″ hex drive bit, or a standard #2 Phillips head drill bit. A standard #2 Phillips head screwdriver may also be used to install the clips.
Package of 100 Black Twin Clips. Clips allow for an additional 16-30AWG wire to be installed alongside the primary wire, for use with grounding of antennas and satellites. Proudly packaged in the USA.
